Headgear Wrap Installation

Items Needed for Your Wrap Installation

CK Signature Headgear
Bowl of tap water
Heatgun or blow dryer
Your Custom Wrap

custom-wrestling-headgear-installation-1

custom-wrestling-headgear-installation-2  

Step 1

Carefully peel one sticker side off and submerge in water.

Step 2

Match up the big side of the wrap to the big side of the headgear first.

custom-wrestling-headgear-installation-4

custom-wrestling-headgear-installation-3  

Step 3

Once the big side is on lay the rest of the sticker on going across and stretching where needed.

Step 4

Once wrap is in place and still wet make sure the center is smooth. Smooth out all of the bubbles as the water dries.

custom-wrestling-headgear-installation-5 

custom-wrestling-headgear-installation-6 

Step 5

Blow dry and smooth out edges on both sides.

(BE CAREFUL NOT TO OVERHEAT THE WRAP OF THE COLOR WILL MELT OFF)

Step 6

Heat the area around the strap holes until it begins to whither but do not over heat. Use your finger to tuck vinyl down into the strap hole for a nice finished look.

custom-wrestling-headgear-installation-5 

custom-wrestling-headgear-installation-9

Step 7

Run over the entire headgear one last time for bubbles and possible areas that need a little more heat and you’re set to go compete!