CK Signature Headgear Bowl of tap water Heat-gun or blow dryer Your Custom Wrap
STEP 1
Carefully peel one sticker side off and submerge in water.
STEP 2
Match up the big side of the wrap to the big side of the headgear first.
STEP 3
Once the big side is on lay the rest of the sticker on going across and stretching where needed.
STEP 4
Once wrap is in place and still wet make sure the center is smooth. Smooth out all of the bubbles as the water dries.
STEP 5
Blow dry and smooth out edges on both sides
(BE CAREFUL NOT TO OVERHEAT THE WRAP OF THE COLOR WILL MELT OFF)
STEP 6
Heat the area around the strap holes until it begins to whither but do not over heat. Use your finger to tuck vinyl down into the strap hole for a nice finished look.
STEP 7
Enjoy the new look and feel of your custom design.